Process Image - WAGO MOVILINK SPEEDWAY 767 Manual

66

Process Image

Pos : 33 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/__ noc h nic ht ei ns ortierte Ü berschriften müss en noc h eins orti ert werden __Pr oz ess abbild - Übersc hrift 1 @ 4\mod_1240983067828_21.doc x @ 31942 @ 1 @ 1
8 Process Image
Pos : 34 /Serie 767 ( WAGO-SPEED WAY)/Proz ess abbild/I/O-Module/Proz ess abbil d 767- xxxx Ei nleitung @ 5\mod_1249373659937_21.doc x @ 40223 @ @ 1
The process images for the module listed in the following sections describe the
data length on the S-BUS (system bus). The implementation of the S-BUS process
images onto the respective fieldbus process images can be found in the fieldbus
coupler manuals.
The process image is divided into two areas: an output data area and an input data
area. The process image can contain process data with and without diagnostic
information, independently of whether the transmission of synchronous diagnostic
information has been selected.
Synchronous diagnostic information
Synchronous diagnostic information designates the cyclical transmission of
diagnostic information in the process image. This is not selected in the original
factory settings for the module.
This is only possible when using a fieldbus coupler that supports the synchronous
diagnostic function (e.g. 767-1101 or 767-2301). Detailed information about
enabling the transmission of diagnostic information can be found in the manual
for the fieldbus coupler being used: see the section about the device description
file.
In addition, you can also switch on synchronous diagnostic information in
fieldbus couplers that support this function by using an FDT/DTM frame
application (e.g. WAGOframe) in the corresponding DTM. For more information,
see the Section "Parameterization via FDT/DTM" > "Diagnostics setting" in the
fieldbus coupler manuals.
Activate module diagnostics
You can enable or suppress the individual module diagnostics. For more
information, see the Section "Diagnostics Overview".
Pos : 35 /Serie 767 ( WAGO-SPEED WAY)/Wic htige Erläuterungen/Sicherheits hinweis e/Hi nweis /Hinweis: Prozess abbil d 767-5xxx @ 8\mod_1278504041994_21.doc x @ 59260 @ @ 1
Diagnostic Actuator short circuit/overload
The "Actuator short circuit/overload" diagnostic is dependent on the switching
status of the outputs (see section "Diagnostics" > "Diagnostic overview".
Pos : 36 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
767-5204 MOVILINK® Interface (RS-232, RS-485)
WAGO-SPEEDWAY 767
Manual
Version 1.1.0