Tools And Accessories Required For Mounting - WAGO MOVILINK SPEEDWAY 767 Manual

WAGO-SPEEDWAY 767
767-5204 MOVILINK® Interface (RS-232, RS-485)
Pos : 22.7 /Serie 767 (WAGO-SPEED WAY)/M ontier en/I/O-Modul e/M ontage_Wer kzeug 767- xxxx allgemein_1 @ 5\mod_1249034240265_21.doc x @ 39783 @ 2 @ 1
4.2

Tools and Accessories Required for Mounting

Depending on the mounting type, the following tools are required for installation:
• A screwdriver for M4 fixing screws
• Drilling machine to pre-drill the mounting holes for the module to be
mounted to the system and, if applicable, for the imperforated carrier rail.
• M4 thread cutter (bottoming tap or hand tap set)
The WAGO accessories listed below are required for mounting. The associated
item numbers can also be found in the 767 Series fieldbus manuals, in the
"Accessories" section. Select the manual appropriate to the fieldbus you are using.
• Carrier rail adapter, including fixing screws and perforated or imperforated
carrier rails (DIN rail 35 x 7.5 or DIN rail 35 x 15) according to EN 60715,
also available from WAGO.
or
• Profile adapter, including fixing screws
• Spacer (optional)
Two M4x12 screws are required for direct mounting of the module. The length of
the screw shaft is to be selected according to the mounting type.
Pos : 22.8 /Serie 767 (WAGO-SPEED WAY)/M ontier en/I/O-Modul e/M ontage_Wer kzeug 767- xxxx allgemein_2 @ 7\mod_1267626863027_21.doc x @ 51695 @ @ 1
Bore measurements
When fastening the 767 Series components without a threaded hole, the clearance
hole must not be wider than 4 mm so as to ensure safe contact of the FG
(functional ground) connections.
Pos : 22.9 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
Mounting 33