WAGO MOVILINK SPEEDWAY 767 Manual page 100

100 Diagnostics
Table 56: Operating messages 1
Pos. LED Color/Status
15 SB
Pos : 44.5 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen 767- 5xxx D IO Allgemein ( Pos. 15, T eil 2) @ 7\mod_1268637618295_21.doc x @ 52466 @ @ 1
15 SB
Pos : 44.6 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Cause
Green and orange, The set substitute value is
flashing, 1 Hz applied to the module.
Orange, flashing, The module has detected the
2 Hz S-BUS.
Orange and green, The last module is being
flashing, 4 Hz detected in the 767 node.
Orange, flashing, The fieldbus coupler is
1 Hz addressing the module in the
767 node.
Orange and green, The S-BUS parameters are
flashing, 2 Hz being stored by the fieldbus
coupler.
Orange The firmware is being
updated.
Orange, flashing, The module is attempting to
4 Hz establish communication with
the fieldbus coupler.
Green, flashing, The module is in HOLD
1 Hz mode.
Green, flashing, The module is in STOP
2 Hz mode.
767-5204 MOVILINK® Interface (RS-232, RS-485)
WAGO-SPEEDWAY 767
Remedy/information
Can be set by the fieldbus
coupler if fieldbus is missing.
Check the fieldbus connection
and the status of the higher-
level controller.
-
Check the S-BUS terminator
and/or the S-BUS cables.
-
-
All 767 Series components
are being updated by the
fieldbus coupler within the
node.
Check the power supply to
upstream 767 Series
component and/or check the
S-BUS cable for damages.
Is initiated by the fieldbus
coupler. In DI mode, the last
input values transferred to the
fieldbus coupler are kept in
the process image. In DO
mode, the last output values
are retained.
Is initiated by the fieldbus
coupler. In DI mode, the input
values are set to 0 in the
process image. In DO mode,
the output value is output as 0.
Manual
Version 1.1.0