Table 57: Operational Messages 2 - WAGO MOVILINK SPEEDWAY 767 Manual

WAGO-SPEEDWAY 767
767-5204 MOVILINK® Interface (RS-232, RS-485)
Pos : 44.7 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen 767- 5204 F, I/O (Pos. 16 + 17) @ 14\mod_1357824357686_21.doc x @ 108282 @ @ 1

Table 57: Operational messages 2

No. LED Color/status
16 F
Ch 1.1
Ch 2.1
17
Ch 1.2
Ch 2.2
17 0 ... 3
Pos : 44.8 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen 767- xxxx U LS und UA (Pos. 18 + 19) @ 8\mod_1278577022948_21.doc x @ 59316 @ @ 1
18 U
A
19 U
LS
Pos : 45 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
Cause
Red There is at least one global
diagnostic message on the
module.
Off No data to send
Yellow flashing Channel sends data
Off No data receipt
Yellow flashing Channel receives data
Yellow Input: Signal active and is
recognized as '1'.
Output: Output signal is
active.
Red* Error on output
* If you set the time of the parameter "Restart delay, actuator" (section
"Parameterizing"> "Output Parameters") to 0 ms, the I/O LED appears yellow
rather than red in case of a short circuit or overload due to the short restart
interval.
Green Actuator supply U
present.
Off Actuator supply U
present.
Green Logic supply and sensor
supply U
Off Logic supply and sensor
supply U
Remedy/information
Check the supply voltages U
and U
Series components. For more
information, see the section
"Parameterizing">
"Diagnostic Overview".
Check the connection of the
external device and that the
transmission parameters
match.
---
Check the connection of the
external device and that the
transmission parameters
match.
---
---
Check the actuator connection
for short circuit/overload. A
short circuit or overload can
only occur when the output is
switched on.
Check the actuator connection
for short circuit/overload.
is -
A
is not Connect the power supply and
A
check the voltage level, if
applicable.
-
are present.
LS
Connect the power supply and
are not present. check the voltage level, if
LS
applicable.
Diagnostics 101
LS
of the upstream 767
A