Disc Inspection - PIAGGIO Beverly Tourer 300 i.e. Service Station Manual

Beverly Tourer 300 i.e.
For fitting, position the disc correctly using the ar-
row stamped on it as reference.
N.B.
THE ARROW STAMPED ON THE DISC INDICATING THE
RUNNING DIRECTION MUST BE FITTED TOWARDS THE
OUTSIDE OF THE VEHICLE.
- Tighten the screws to the prescribed torque and
apply the recommended product.
Recommended products
Loctite 243 Medium strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Brake disc screws
8 to 10

Disc Inspection

Checking the disc is important; it must be perfectly
clean, with no sign of rust, oil or grease or any oth-
er dirt, and must show no signs of deep scoring.
Characteristic
New rear disc thickness
4.0 mm
Disc thickness at wear limit (rear)
3.5 mm
- Using the specific tool, check that the axial run-
out of the brake surface is within the prescribed
limits.
- If this is not the case, replace the disc and repeat
the test.
WHEN INSTALLING, THOROUGHLY CLEAN THE DISC
AND ITS SEAT ON THE HUB.
Characteristic
Max. axial run-out
0.1 mm
Braking system
BRAK SYS - 245