Rear Brake Pads - PIAGGIO Beverly Tourer 300 i.e. Service Station Manual

Braking system
See also
Front
brake calliper
Refitting
To fit, proceed as follows:
- Insert the two pads in the callipers.
- Screw the two pad lock pins to the correct torque, and apply the recommended product.
- Fit the calliper on its support, tightening the two screws to the prescribed torque.
N.B.
IF IT IS NOT POSSIBLE TO CORRECTLY POSITION THE CALLIPER ON THE DISC DURING FIT-
TING, GENTLY EXPAND THE PADS.
Recommended products
Loctite 243 Medium strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Pad fixing pin 19.6 ÷ 24.5

Rear brake pads

Removal
- Remove the rear brake calliper
- Loosen the two pins shown in the figure that lock
the two pads; be careful with the pad spring clamp.
- Remove the brake pad and check there are no
faults or warping. Replace it if such anomalies are
present.
- Check the thickness of the friction material is
more than 1.5 mm. If it is not, replace it
BRAK SYS - 248
Beverly Tourer 300 i.e.