Engine Oil - PIAGGIO Beverly Tourer 300 i.e. Service Station Manual

Maintenance

Engine oil

Replacement
Change oil and replace filter as indicated in the
scheduled maintenance table.
- In order to facilitate oil drainage, unscrew the cap/
dipstick «A».
- Unscrew the mesh pre-filter drainage plug «B»
on the flywheel side and let the oil drain off.
- Once all the oil has drained through the drainage
hole, unscrew and remove the oil cartridge filter
«C ».
Make sure the pre-filter and drainage plug O-rings
are in good conditions. Lubricate them and refit the
mesh filter and the oil drainage plug, screwing
them up to the prescribed torque.
Refit the new cartridge filter being careful to lubri-
cate the O-ring before fitting it.
Add the recommended engine oil through plug
«A». Then start up the vehicle, let it run for a few
minutes and shut it off. After five minutes check the
level and if necessary top up without exceeding the
MAX level. The cartridge filter must be replaced
every time the oil is changed.
N.B.
THE ENGINE MUST BE HOT WHEN THE OIL IS CHANGED.
Recommended products
AGIP CITY HI TEC 4T Engine oil
MAIN - 46
Beverly Tourer 300 i.e.