PIAGGIO Beverly Tourer 300 i.e. Service Station Manual page 113

Beverly Tourer 300 i.e.
Engine from vehicle
- Remove the cables from the retainer clamps on
the flywheel cover.
- Remove the clamp indicated.
- Disconnect the oil minimum pressure sensor.
- Remove the lower screws of the right and left
shock absorber.
When refitting the engine onto the vehicle, carry
out the removal operations but in reverse order
and respect the tightening torques shown in the
Specifications Chapter.
- Check the engine oil level and if necessary, top
it up with the recommended type.
- Fill and bleed the cooling circuit.
- Check accelerator and electric devices for correct
functioning.
CAUTION
PAY PARTICULAR ATTENTION TO POSITIONING THE
THROTTLE CONTROL TRANSMISSION PROPERLY.
ENG VE - 113