Beverly Tourer 300 i.e.
- The replacement must be made with greater re-
sidual thickness if the pad has not worn evenly. A
0.5 mm thickness difference in the residual friction
material is permitted.
See also
Removal
Refitting
To fit, proceed as follows:
- Insert the two pads in the callipers.
- Screw the two pad lock pins to the correct torque,
and apply the recommended product.
- Fit the calliper on its support, tightening the two
screws to the prescribed torque.
N.B.
IF IT IS NOT POSSIBLE TO CORRECTLY POSITION THE
CALLIPER ON THE DISC DURING FITTING, GENTLY EX-
PAND THE PADS.
Recommended products
Loctite 243 Medium strength threadlock
Medium Loctite 243 threadlock
Locking torques (N*m)
Screw tightening calliper to support
fixing pin
19.6 ÷ 24.5
Fill
Pad
24 to 27
Braking system
BRAK SYS - 249