Suspensions
Soap-based lithium and zinc oxide grease con-
taining NLGI 2; ISO-L-XBCIB2
Rear
Removing the rear wheel
- Remove the muffler mounting bracket
- Remove the 5 screws shown in the picture
Refitting the rear wheel
- Carry out the removal operations but in reverse order, observing the prescribed tightening torques.
Locking torques (N*m)
Fixing screw for wheel rim to hub 33 - 37
Swing-arm
Removal
- Place the vehicle on its centre stand;
- Support the engine adequately;
- Loosen the nut shown in the figure and pull out
the pin from the left-hand side.
SUSP - 230
Beverly Tourer 300 i.e.