PIAGGIO Beverly Tourer 300 i.e. Service Station Manual page 87

Beverly Tourer 300 i.e.
- 1-flash code
- 2-flash code
- 3-flash code
Diagnostic code - 1 flash
A one-flash code indicates a system where the se-
rial line is not present or is not detected. Check the
Immobilizer aerial wiring and change it if necessa-
ry.
Diagnostic code - 2 flashes
A two-flash code shows a system where the con-
trol unit does not show the transponder signal. This
might depend on the inefficiency of the immobiliser
aerial or the transponder.
Turn the switch to «ON» using several keys: if the
code is repeated even with the Master key, check
the aerial wiring and change it if necessary. If this
is not the case, replace the defective key and/or
reprogram the control unit.
Diagnostic code - 3 flashes
A three-flash code indicates a system where the
control unit does not recognise the key. Turn the
switch to «ON» using several keys: if the error
code is repeated even with the Master key, replace
the control unit. If this is not the case, reprogram
the decoder.
Electrical system
ELE SYS - 87