PIAGGIO Beverly Tourer 300 i.e. Service Station Manual page 125

Beverly Tourer 300 i.e.
Inspecting the clutch spring
- Measure the length of the spring when it is re-
laxed.
Characteristic
Standard length
123 mm
Acceptable limit after use:
118 mm
Refitting the clutch
- Support the driven pulley spring compressor spe-
cific tool with the control screw in vertical axis.
- Arrange the tool with the medium length pins
screwed in position "C" on the inside.
- Introduce the adapter ring No. 11 with the cham-
fering facing upwards.
- Insert the clutch on the adapter ring.
- Lubricate the end of the spring that abuts against
the torque server closing collar.
- Insert the spring with its plastic holder in contact
with the clutch.
- Insert the drive belt into the pulley unit according
to their direction of rotation.
- Insert the pulley unit with the belt into the tool.
- Slightly preload the spring.
- Make sure that the clutch is perfectly inserted into
the adapter ring before proceeding to tighten the
clutch nut.
- Place the tool in the clamp with the control screw
on the horizontal axis.
- Fully preload the spring.
- Apply the clutch fixing nut and tighten it to the
prescribed torque using the special 46x55 wrench.
- Loosen the tool clamp and insert the belt accord-
ing to its direction of rotation.
Engine
ENG - 125