Beverly Tourer 300 i.e.
Centre-stand
- Remove the two return springs from the centre
stand.
- Undo the nut shown in the figure.
- Remove the pin from the right side.
- Remove the centre stand.
- On refitting tighten the nut to the specified torque.
Locking torques (N*m)
Centre stand bolt
40 ÷ 45
Side stand
Removal of the side stand
- Unhook the springs;
- Loosen the nut;
- Pull out the screw;
Fitting
Carry out the previous operations but in reverse
order.
Locking torques (N*m)
Side stand fixing bolt
40 ÷ 45
Suspensions
SUSP - 239