PIAGGIO Beverly Tourer 300 i.e. Service Station Manual page 109

Beverly Tourer 300 i.e.
This section describes the operations to carry out when removing the engine from the vehicle.
Exhaust assy. Removal
- Remove the RH footrest.
- Remove the Lambda probe from its support and
disconnect it.
- Cut the fastening clamp on the lambda probe ca-
ble.
- Undo the two exhaust manifold fixings on the
head. To unscrew the nuts that fix the silencer
flange to the head properly, use a jointed wrench
that allows, according to the travel direction, to get
also at the right nut. That is difficult to do with a
traditional straight wrench.
- Undo the three screws that fix the silencer to the
supporting arm.
- Remove the full silencer unit.
Engine from vehicle
ENG VE - 109