Beverly Tourer 300 i.e.
- Fit the two screws on the outside of the timing
chain side and tighten them to the specified torque.
N.B.
BEFORE INSTALLING THE HEAD, MAKE SURE THAT THE
LUBRICATION CHANNEL IS CLEAN USING A COM-
PRESSED AIR JET.
Locking torques (N*m)
Timing chain tensioner support screw
Refitting the rocker-arms cover
- Refit the cylinder head cover and tighten the 5
clamping screws to the prescribed torque.
- Make sure the gasket is positioned properly.
Locking torques (N*m)
Tappet cover screws
Refitting the intake manifold
- Fit the intake manifold and do up the three
screws.
Locking torques (N*m)
Intake manifold screws
11 to 13
6 - 7 Nm
11 to 13
Engine
ENG - 155