Preparing Fixed Section; Fitting The Frame; Fitting The Installation To The Wall - Eaton Magnefix MD4 User Manual

3.4.7

Preparing fixed section

1. Remove the switch caps and the fuse caps from the
switchgear.
N
OTE
Make sure no dust or dirt can penetrate into the
switch and fuse caps.
2. Lay the fixed part of the switchgear on wooden blocks
to avoid damage to the interlock.
3. Fit the braces (h) using the fasteners.
3.4.8

Fitting the frame

1. Lay the frame on the braces and attach it to the fixed
section using the fasteners.
2. Fit the other suspension beam (k) to the vertical posts
(a) using the fasteners supplied.
3. Check that all bolts and nuts have been tightened
firmly.
3.4.9

Fitting the installation to the wall

1. Fit the unit to the wall, using the suspension beams
(k). Do this using the four spacers (j)
Connect the earth bar (f) to the earthing system.
2.
2, 3
1
2, 3
1
Magnefix MD4
991.184 G01 03 29