Position The Switchgear On The Frame; Fitting The Dust Cap - Eaton Magnefix MD4 User Manual

3.3.11 Position the switchgear on the frame

1. Unpack the switchgear.
2. Remove any switch and fuse caps, if installed.
3. Remove the switch caps and the fuse caps from the
switchgear.
N
OTE
Make sure no dust or dirt can penetrate into the
switch and fuse caps.
4. Place the switchgear in the frame (a).
5. Fit the switchgear to the frame using the shafts (1) and
safety rings (2).
N
OTE
Fit the safety rings to the outer surface of the
frame.
6. Move the installation to the correct location and anchor
the frame to the floor.

3.3.12 Fitting the dust cap

1. Fit the dust cap between the side plates.
4, 5
1
Magnefix MD4
991.184 G01 03 25