Cleaning Clear Plastic And Acrylic Surfaces; Cleaning Metal Surfaces; Cleaning Wood Surfaces; Cleaning The Reusable Skin Probe - Dräger Resuscitaire WBR82 Instructions For Use Manual

PROPRIETARY AND CONFIDENTIAL DRAFT 5 Feb 04

Cleaning Clear Plastic and Acrylic Surfaces

CAUTION:
Do not use alcohol, acetone, or any organic solvents for cleaning. Alcohol can cause crazing of
plastic and acrylic.
CAUTION:
Do not expose plastic and acrylic to direct radiation from germicidal lamps. Ultraviolet radiation
from these sources can cause cracking and crazing of clear plastic and acrylic.
1. Use an EPA-registered disinfectant-detergent, such as cold sterilants and quarternary ammonium
compound disinfectants to clean all surfaces thoroughly. Make sure to clean all holes and
indentations.
2. Dry with a clean cloth or paper towel.

Cleaning Metal Surfaces

WARNING:
The heater assembly may be hot enough to cause burns. Before cleaning or touching the
warmer head, allow 30 min for the unit to cool sufficiently after removing power from the unit.
Failure to do so could result in personal injury.
CAUTION:
Avoid cleaning metal surfaces with products containing bleach type cleaners which are
corrosive to metal surfaces. Failure to do so could result in equipment damage.
Use an EPA-registered disinfectant-detergent, such as cold sterilants and quarternary ammonium
compound disinfectants to clean all surfaces thoroughly. Make sure to clean all holes and indentations,
and then dry with a clean cloth or paper towel.

Cleaning Wood Surfaces

Use a disinfectant-detergent to clean all surfaces thoroughly, and then dry with a clean cloth or paper
towel.

Cleaning the Reusable Skin Probe

WARNING:
Disposable probes are for single-patient use and must be disposed of after use. Failure to do so
could result in patient injury.
CAUTION:
Do not pull on the tip of the skin probe when cleaning or drying. Probe damage could occur.
Use a disinfectant-detergent to clean all surfaces thoroughly, and then dry with a clean cloth or paper
towel.
6 - 3