Universal Cylinder Bracket - Dräger Resuscitaire WBR82 Instructions For Use Manual

PROPRIETARY AND CONFIDENTIAL DRAFT 5 Feb 04

Universal Cylinder Bracket

CAUTION:
When installing the cylinder, ensure that the universal cylinder bracket aligns the outlet of the
cylinder with the gas inlet on the back of the unit. Injury or equipment damage could occur.
The universal cylinder bracket can be adjusted to secure the cylinder in the proper position. It consists of
two metal parts: one mounting plate attached to the lower post of the warmer and an outer bracket that
mates with the cylinder. There is also a strap to secure the cylinder to the outer bracket.
1. Once the cylinder is properly installed on the RW82,
wrap the cylinder strap (A) around the cylinder.
2. Close the latch (B).
3. Pull on the strap until it is secure.
1. Once the cylinder is properly installed on the WBR82,
slide the outer bracket (A) away from the lower post
until the bracket meets the cylinder.
2. Tighten the nuts on the screw posts (B) located on the
sides of the inner bracket until secure.
3. Wrap the cylinder strap (C) around the cylinder, close
the latch, and pull on the strap until it is secure.
5 - 20
B
A
B
B
A
C