Nortel Meridian 1 Description, Installation And Operation page 217

15 Install the replacement IP Line card into the card slots in the Meridian 1
IPE module or option 11 cabinet:
Note: Refer to Appendix A for detailing instructions on connecting the
T-LAN cable to the IP Line card in the Option 11 cabinet.
• Pull the top and bottom locking devices away from the ITG
faceplate.
• Insert the IP Line card into the card guides and gently push it until it
makes contact with the backplane connector. Hook the locking
devices.
Note 1: When IP Line cards are installed, the red LED on the faceplate
remains lit until the card is configured and enabled in software, at which
point in turns off. If the LED does not follow the pattern described or
operates in any other manner (such as continually flashing or remaining
weakly lit), replace the card.
Note 2: Observe the ITG faceplate maintenance display to see startup
selftest results and status messages. A display of the type "F:xx"
indicates a failure. Some failures indicate that the card must be replaced.
"F:10" indicates Security Device test failure: check for presence of
Security Device on the card. Refer to "Prior to communication with the
Meridian 1, the 8051XA controller will download FPGA data files and
perform tests to ensure correct programming of the FPGA." on page 241
for a listing of display codes.
16 In the Meridian 1 large system IPE module, attach the T-LAN Ethernet
cable to the faceplate of the replacement IP Line card.
Note: Refer to Appendix A for detailing instructions on connecting the
T-LAN cable to the IP Line card in the Option 11 cabinet.
Note: When connecting the IP Line card to the T-LAN, the link status
LED on the ITG faceplate associated with the voice interface will light
green when the connection is made, and the link status LED on the hub
port will also light green when connected to the IP Line card.
17 In the MAT "IP Telephony Gateway" main window, select
and verify that the replacement IP Line card status is
View | Refresh
showing "Unequipped."
ITG Line 1.0/IP Telecommuter Description, Installation and Operation
Maintenance Page 217 of 262