Nortel Meridian 1 Description, Installation And Operation page 112

Page 112 of 262
553-3001-119 Standard 2.00 April 2000
Installation and configuration
Leave the radio button default setting of "Transmit to selected nodes".
3
Check the "Node Properties to the active leader" check box.
Note: Card Properties and Gatekeeper Properties will be transmitted in
"Transmit card properties and Gatekeeper properties" on page 122.
Note: IP Line cards are delivered with software pre-installed in the
onboard flash memory, so a transmitting new card software may not be
required during installation. After the Node Properties have been
transmitted and MAT has established communication with the IP Line
card, you will verify the software on the cards. To re-install or upgrade
to a new version, refer to the Administration and maintenance chapter.
6WDUW#7UDQVPLW
Click the
4
Monitor progress in the "Transmit Control" window. Confirm that the
node properties are transmitted successfully.
When the transmission is complete, click the
5
Reboot the Leader 0 IP Line card.
6
After successfully rebooting, the Leader 0 card is now fully configured with
the Node Properties of the node and enters a state of "active leader". The
Leader 1 card is now auto-configured, reboots automatically, and enters the
state of "backup leader". Any follower cards are now auto-configured with
their IP addresses. MAT ITG should now be in communication with all cards
in the ITG node.
Note: If you are installing ITG from a remote MAT ITG PC and if you
cannot communicate with the node after transmitting the node properties
and rebooting the Leader 0 card, this means that the ITG cards are unable
to communicate back to the remote MAT ITG PC through the voice
gateway. To reestablish communication with the ITG node, you may
connect to the ITG maintenance port and use the ITG shell 'routeAdd'
command on each ITG card to add a new IP route that points to the
remote MAT ITG PC subnet. This step must be repeated every time a
card is reset until the card properties (containing the SNMP Manager IP
addresses) have been successfully transmitted to the card.
button.
&ORVH
button.