Nortel Meridian 1 Description, Installation And Operation page 173

Note: Refer to and update the IP Line card TNs on the IP Line card
Installation Summary Sheet.
Remove any existing I/O panel cabling associated with any card formerly
9
installed in the selected card slot.
10 Pull the top and bottom locking devices away from the IP Line card
faceplate.
11 Insert the IP Line card into the card guides and gently push it until it
makes contact with the backplane connector. Hook the locking devices.
Note 1: When IP Line cards are installed, the red LED on the faceplate
remains lit until the card is configured and enabled in software, at which
point it turns off. If the LED does not follow the pattern described or
operates in any other manner (such as continually flashing or remaining
weakly lit), replace the card.
Note 2: Observe the IP Line card faceplate maintenance display to see
start-up selftest results and status messages. A display of the type "F:xx"
indicates a failure. Some failures indicate that the card must be replaced.
"F:10" indicates Security Device test failure: check for presence of
Security Device on the card. Refer to "Faceplate maintenance display
codes for card reset" on page 208 for a listing of display codes.
To configure the new IP Line card, do the following:
12 In the "IP Telephony Gateway - IP Telecommuter" window,
double-click on the IP Line card to display the "IP Line card Properties"
window. Leave the IP Line card icon selected in the left side of the
window.
ITG Line 1.0/IP Telecommuter Description, Installation and Operation
Administration Page 173 of 262