Nortel Meridian 1 Description, Installation And Operation page 216

Page 216 of 262
553-3001-119 Standard 2.00 April 2000
Maintenance
12 Select Leader 0 or any IP Line card in the node.
13 Use the
Configuration | Synchonize | Transmit
Node Properties from MAT to the active leader card (Leader 0 or Leader
1) of the ITG node. Leave the default radio button selection "Transmit to
Selected Nodes". Check the
. This will update the node properties on the active leader card
Transmit
with the MAC Address of the replacement IP Line card.
14 Install the Security Device that was removed from the faulty IP Line card
into the replacement IP Line card.
Note: Be careful not to bend the Security Device retaining clip when
removing or inserting the Security Device. If the replacement card
cannot read the Security Device later in this procedure, gently bend the
spring clip down, to increase contact pressure between the spring clip and
the Security Device.
command to transmit the
box, and then click
Node Properties Start