Nortel Meridian 1 Description, Installation And Operation page 198

Page 198 of 262
7UDQVIHU#ILOHV#YLD#WKH#FRPPDQG0OLQH#LQWHUIDFH
553-3001-119 Standard 2.00 April 2000
Administration
The following commands give additional information about an IP Line card:
• ldrResTableShow
• ifShow
• dongleIDShow
• serialNumShow
• firmwareVersionShow
• swVersionShow
• emodelSim
To transfer a file from the IP Line card to the MAT PC or from the MAT PC
to the IP Line card, perform the one of the following commands at the ITG
shell command-line, depending on what type of file transfer is to occur. These
commands are from the perspective of the IP Line card: that is, commands
containing "Get" as part of the command refer to file transfer from the MAT
PC to the IP Line card, while commands containing "Put" as part of the
command refer to file transfer from the IP Line card to the MAT PC:
The "bootptab.1" file (transferred by the "bootPFileGet" and "bootPFilePut"
commands) contains node properties information. The "config1.ini" file
(transferred by the "configFileGet" command) contains card properties
information. The "bootptab.1" file only goes to the active Leader card, while
the "dptable.1" and "config1.ini" files go to every IP Line card.