Nortel Meridian 1 Description, Installation And Operation page 199

Note 1: These commands are case-sensitive. The parameters following
the command must each be enclosed in quotes, and that there must be a
comma and no spaces between the parameters.
Note 2: Refer to the Maintenance section for a complete description of
the various ITG shell file transfer commands.
Note 3: Hostname refers to the either IP address of the FTP host, or the
IP Line card itself or another IP Line card when a PC card in the A: drive
or C: drive (the swDownload command must only use the A: drive), of
the IP Line card contains the software binary file.
‡ #
swDownload <hostname> <username> <password>
<directory path> <filename>
This command updates the software on the IP Line card with the binary
file received from an FTP server or IP Line card (from the drive A: PC
card) corresponding to the hostname IP address. The IP Line card FTP
client performs a get which downloads the file to the ITG flash bank. A
checksum is calculated to verify correct delivery. Once the new software
version is successfully downloaded, the IP Line card must be rebooted
with cardReset in order to run the new software.
• configFileGet <hostname> <username> <password>
<directory path> <filename>
• bootPFileGet <hostname> <username> <password>
<directory path> <filename>
‡
SNMPConfFileGet
<directory path> <filename>
• hostFileGet <hostname> <username> <password>
<directory path> <filename> <ITGFileName> <listener>
• currOmFilePut <hostname> <username> <password>
<directory path> <filename>
prevOmFilePut <hostname> <username> <password>
•
<directory path> <filename>
• traceFilePut <hostname> <username> <password>
<directory path> <filename>
ITG Line 1.0/IP Telecommuter Description, Installation and Operation
Administration
#
<hostname> <username> <password>
Page 199 of 262