Nortel Meridian 1 Description, Installation And Operation page 200

Page 200 of 262
,3#FRQILJXUDWLRQ#FRPPDQGV
'RZQORDG#WKH#,7*#HUURU#ORJ
553-3001-119 Standard 2.00 April 2000
Administration
• currLogFilePut <hostname> <username> <password>
<directory path> <filename>
prevLogFilePut <hostname> <username> <password>
•
<directory path> <filename>
• configFilePut <hostname> <username> <password>
<directory path> <filename>
‡
bootPFilePut
<directory path> <filename>
• hostFilePut <hostname> <username> <password>
<directory path> <filename> <ITGFileName>
The one command that does all the necessary actions to make a leader. Sets
IP address, gateway, subnet mask, boot method to static, and leader bit in
NVRAM.
• setLeader
Enter this command to clear the leader info in NVRAM and set the boot
method to use bootp, thus, making the card a follower:
• clearLeader
(QWHU#WKLV#FRPPDQG#WR#SULQW#WKH#YDOXHV#RI#WKH#,3#SDUDPHWHUV#WKDW#UHVLGH#LQ#
195$01
• NVRIPShow
The ITG error log contains error conditions as well as normal events. Some
of the error conditions may be severe enough to raise an alarm through SNMP
traps.
The following commands are used to download an ITG error log:
• currLogFilePut
• prevLogFilePut
#
<hostname> <username> <password>