Table of Contents
Advertisement
Chapter 3
To Connect the Harness Cable
Route the harness cable (P/N 115-0230-003) toward the machine's cab.
1.
Connect the harness cable to the controller cable (P/N 115-0230-002). Tighten the connector screw cap to
2.
secure.
Note:
Be sure the allow enough slack in the harness cable to allow for boom racking.
Connect the Controller
Controller Connectors
FIGURE 18.
Route the Controller Cable (P/N 115-0230-002) into the machine cab, on the right-hand side.
1.
Locate the two controller connectors. Connect these connectors to the AutoBoom Controller.
2.
Note:
The AutoBoom Controller should be mounted in the machine cab so that the machine operator will
have easy access to it.
To Connect the Power Leads
Locate the power cable that has the red and white power leads at one end.
1.
Disconnect the machine's connectors from the battery terminals.
2.
Install the red power lead on the positive battery terminal and reinstall the machine's battery connector.
3.
Install the white power lead on the negative battery terminal and reinstall the machine's battery connector.
4.
24
John Deere 4700 (1998 and Older) AutoBoom Installation Manual
Advertisement
Table of Contents
