D5 Smart Maintenance - CENTURION SYSTEMS D5 SMART Installation Manual

SECTION 9

9.2. D5 SMART Maintenance

Before performing any maintenance, ensure that the D5 SMART is
isolated!
Description
Check for insect
infestations
Check that the M10
half-nuts are tight on
the foundation plate
bolts
Check that there is no
sand build-up inside the
unit
Check pinion and rack
engagement
Check the condition of
the pinion
Check the condition of
the override cam lock
If used, check the
condition of the theft-
deterrent cage
If used, check the
condition of the theft-
deterrent cage lock and
that it operates
Check the oil level and
inspect the gearbox for
any oil leaks
Frequency
Every 3 months
Every 6 months
Every 6 months
Every 6 months
Every 6 months
Every 6 months
Every 6 months
Every 6 months
Every 6 months
page 55
Corrective Action
Clean and remove any nests that are
settling in and around the motor and
Control Card
Insert a moth ball, which may
help to repel insects, at the
bottom of the gearbox
Torque setting 20Nm
Remove batteries and lower battery
tray and clear out the sand build-up
If the mesh is too loose or the rack is
riding on the pinion, contact an installer
to correct
If the pinion is excessively worn,
contact an installer to replace
Dry lubricate if necessary (graphite)
Ensure that the device is serving its
purpose
Dry lubricate if necessary (graphite)
Using the oil dipstick,
top up if necessary with
Centurion Systems (Pty) Ltd
approved oil.
(Section 6 - "Lubrication")
If there are any oil leaks,
contact an installer to evaluate
GENERAL MAINTENANCE
TABLE 4
www.centsys.com