Re-Assembling The D5 Smart; Override Sensor; Routing The Override Sensor Harness - CENTURION SYSTEMS D5 SMART Installation Manual

SECTION 7

7.10. Re-assembling the D5 SMART

7.10.1. Override Sensor

If the Override Sensor has previously been removed, take note of how it is
placed back into position correctly, before continuing with the installation.
Override
Sensor
Override
Sensor
Locating Slot
Note the
orientation of the
Override Sensor

7.10.2. Routing the Override Sensor Harness

It is important to ensure that the harness for the Override Sensor is routed
through the correct location when inserting the Lower Battery Tray back into
position.
The Override Sensor harness is
routed directly in front of the electric
motor.
There is a groove located in the
middle of the Lower Battery Tray, on
the motor's side. The harness needs
to be routed between the electric
motor and the Lower Battery Tray
here as the Lower Battery Tray is
placed back into position.
Push the Override Sensor "A" firmly
until it seats onto the gearbox "B"
FIGURE 69. OVERRIDE SENSOR
Lower
Battery Tray
page 42
OPERATOR INSTALLATION
A
B
Groove for
Harnesses
FIGURE 70
www.centsys.com