Table of Contents
Advertisement
6.2 Lubrication overview
6
4
1. Rear axle bearing
2. Link rod
3. Articulation bearing
4. Front axle bearing
5. Steering cylinder
6. Lift chain axle
6.3 Lubrication, general information
•
Remove the ignition key to prevent accidental
movements during lubrication.
•
Use engine oil when you lubricate with an oil can.
•
When you lubricate with grease, use a chassis or
ball bearing grease that prevents corrosion. Remove
unwanted grease after lubrication.
•
Lubricate 2 times a week if you operate the product
daily.
•
Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean with
662 - 001 - 23.10.2018
3
1
4
1
5
alcohol. If the friction between the drive belt and the
pulley is not sufficient after you clean with alcohol,
replace the drive belt.
CAUTION: Do not use gasoline or other
petroleum products to clean drive belts.
6.4 To lubricate cables
•
Lubricate the 2 ends of the cables and move the
controls to the end positions.
•
Attach the rubber covers on the cables after
lubrication.
•
Cables with casing must be lubricated regularly to
prevent malfunction.
a) Remove the cable and hang it vertically.
1
2
Servicing - 15
Hide quick links:
Advertisement
Table of Contents
