Husqvarna P524 EFI Workshop Manual page 51

16. Remove the 6 nuts of the side panel and lift the side
panel.
17. Remove the hydraulic oil tank.
18. Assemble in opposite sequence.
9.5.14 To disassemble the lift cylinder
1. Lower the cutting deck.
2. Remove the frame tunnel cover. Refer to
the covers on page 23 .
3. Push the spring stay to release the lift chain.
4. Remove the operator seat. Refer to
and assemble the seat on page 24 .
5. Disconnect the hydraulic connections of the lift
cylinder. Obey the instructions given in
hydraulic system clean on page 44 .
662 - 001 - 23.10.2018
6. Disassemble the hydraulic couplings at the 2 ends of
7. Remove the lift cylinder through the frame.
8. Assemble in opposite sequence.
To remove
9. Lower and lift the lift arms again and again with the
10. Do a check for leakage from the lift cylinder
11. Do a check of the oil level of the hydraulic oil tank.
9.5.15 Hydrostatic transmission cable
9.5.15.1 To replace the hydrostatic transmission
cable
To disassemble 1. Remove the frame tunnel cover. Refer to
2. Disconnect the front ball socket of the hydrostatic
To keep the
the lift cylinder.
engine started to bleed the lift cylinder.
hydraulic connections.
Fill with hydraulic oil if it is necessary. Refer to
a check of the oil level in the hydraulic system on
page 46 .
the covers on page 23 .
transmission cable.
To do
To remove
Repair instructions - 51