Husqvarna P524 EFI Workshop Manual page 41

9.3.7 To replace the ignition switch
1. Remove the side cover of the control panel. Refer to
To remove the covers on page 23 .
2. Disconnect the ignition switch connection from the
circuit board.
3. Remove the ignition key.
4. Remove the washer and nut below the ignition key.
5. Push the ignition switch down through the control
panel.
6. Assemble in opposite sequence.
9.3.8 To replace the hour meter
1. Remove the steering column cover. Refer to
remove the covers on page 23 .
2. Disconnect the cables from the hour meter.
662 - 001 - 23.10.2018
3. Compress the clips on the hour meter and push out
the hour meter.
4. Assemble in opposite sequence.
9.3.9 To replace the PTO button
1. Remove the side cover of the control panel. Refer to
To remove the covers on page 23 .
2. Disconnect the PTO button connection from the
circuit board.
To
3. Remove the screw that holds the circuit board and
move the circuit board to the side.
Repair instructions - 41