Pto Gear Selection Lever; Operation Of The Hydraulic Circuit; Position Control - Zetor HORTUS HS Series Operator's Manual

PTO Gear Selection Lever

Your tractor is equipped with 2 Speed PTO to suit range of
applications and conditions.
1 - PTO Shift Lever
MODEL POSITION
1st
HORTUS 540
CL65 / HS65
Important: Always use the clutch when engaging or disengaging the PTO or changing PTO
speed. Let the PTO driven implement come to a complete stop before changing.

Operation of the Hydraulic Circuit

The external and internal hydraulic circuits are driven by
a engine-driven hydraulic pump and controlled by a lever
located next to the driver.
1. Position control lever
Caution: When working with the 3-point linkage, keep well clear of the operating radius of the
lift arms and any attached implement. This is to avoid the risk of injury in the case of incorrect
manoeuvres.

Position Control

Implements can be raised and lowered with the hydraulic position control lever and can be stopped at any
position by stopping the lever.
To ensure a consistent working depth the adjustable stop can be set to ensure that the implement returns to
the same depth every time.
To raise the implement: Pull the lever back.

To lower the implement: Push the lever forward.

WARNING: After finishing work, always lower the implement to the ground and switch off the
engine. Apply the parking brake to prevent injuries and accidents.
60
DESCRIPTION OF TRACTOR CONTROLS
2nd 3nd
750 1,000
HODP071
HODP072