Creep Shift Lever - Zetor HORTUS HS Series Operator's Manual

Creep Shift Lever

1. Creep Shift Lever
Move the lever to 'OFF' for high speed and to 'ON' for low
speed.
Shifting requires depressing the clutch.
1. Creep speed (achieved by shifting the creep speed
lever to the ON position) should only be used to perform
one of the following tasks
Deep rotary tillage and plow work

Planting, etc.

2. Creep speed should not be used for any of the following activities
Transport

Front loader operation

Front blade operation

Reloading of soil

Entry and exit of the field

3. To avoid injury:
When leaving the tractor, make sure to apply the parking brake and switch off the engine

When using brakes:

- The wheel axle torque is extremely high when using creep speed. Make sure you fully depress the clutch
pedal before using the brakes, otherwise they may be damaged.
- Make sure that the parking brakes are released when starting to operate the tractor. Improper use of the
brakes can cause damage to the transmission and is therefore unacceptable under Zetor warranty coverage.
4. The 'M' or 'H' reverse gear cannot be turned on when the creep speed is being used.
Important: Press the clutch pedal completely down and stop the tractor's motion before
shifting the creep speed gear lever.
DESCRIPTION OF TRACTOR CONTROLS
HODP065
57