Shuttle Shift Lever - Hs Model; Gear Shift Lever - Zetor HORTUS HS Series Operator's Manual

Shuttle Shift Lever - HS Model

This lever is to switch between forward driving and
reverse driving. Set it in the position N unless driving.
Forward driving - Pull up the lever and push it

forward to drive forwards.
Reverse driving - Pull up the lever and pull it

backward to drive backwards. Then, the reverse
driving buzzer sounds.
1 - Shuttle Shift Lever
Note: The vehicle can start off by operating the shuttle shift lever regardless of the position of the clutch
pedal. Therefore, care should be taken.
Warning:
Do not operate the shuttle shift lever during driving. You can get injured by impact due to

inertia. Change the driving direction after stopping the vehicle.
Operate the shuttle shift lever only when seated in the driver's seat.

Note: The response speed can vary as follows according to the operating speed or operating environment
(temperature) of the hydraulic clutch:
Low operating oil temperature (in cold weather or initial tractor operation): The response may

become faster (abrupt starting). Therefore, operate the clutch at a low speed, and operate the
shuttle shift lever after warming up the engine sufficiently.
High operating oil temperature (after prolonged use of the machine): The response may

become slower, but this is normal.

Gear Shift Lever

This lever can be shifted by using the clutch, both when the tractor is stationary or mobile.
It is located on the R.H.S of the driver seat.
1. Seat Belts
2. Gear Shift Lever
3. Seat Adjustment Knob
4. Seat Adjustment Lever
5. Reduced and Road Gears Shift Lever
DESCRIPTION OF TRACTOR CONTROLS
HODP062
HODP063
55