Lever Of Shifting Of Speed 540 (Or 540E) And 1,000 Rpm Of The Rear Output Shaft; Pto Selection Control Lever; Lever Of Hand Brake And Hitch For Single-Axle Trailer - Zetor Proxima GP Series Operator's Manual

Lever of shifting of speed 540 (or 540E) and 1,000 rpm of the rear output shaft

Shifting can be carried out when the tractor is in standstill
by pulling up or pushing down the lever.
-1
a - 1,000 min
(or 540E min
-1
b - 540 min
* The tractor can be equipped optionally by 6-, 8- or 21-
groove termination of the output shaft.
Shifting of 540 and 1,000 (or 540E) min
possible regardless to the number of grooves on the
installed termination. Speed of the output shaft and
type of the termination shall be chosen depending on
the prescribed speed of the aggregated machine.

PTO selection control lever

a - Independent speed of PTO shaft - PTO shaft speed de-
pends upon the engine speed
n - Neutral
b - Ground speed of PTO shaft (through gearbox) - PTO
shaft speed depends upon the engaged gear speed
Shifting is made when the tractor stops.

Lever of hand brake and hitch for single-axle trailer

1. Hand brake lever.
2. Lever of the single-axle trailer hitch control.
When stopping or leaving the tractor you must
always secure the tractor with the parking brake.
If the tractor is standing on a slope, its wheel must be
additionally secured with wedges!
GETTING TO KNOW THE TRACTOR
-1
)
-1
is
48
G153a
G154
E155