Third-Party Labels On Brainlab Collimators - Brainlab RT/RS Hardware User's Manual

Collimator Mount
2.3.7

Third-Party Labels on Brainlab Collimators

General Information
Brainlab has authorized users and third-party linear accelerator manufacturers to attach labels to
the Brainlab Conical Collimators. Brainlab warrants that the terms of Brainlab warranty or service,
where applicable, will not be affected if the instructions below are followed.
Placing Labels
Those labels may only be placed within the area depicted in Figure 18.
Safety Notes,
The applied label must not cover any original markings of the Brainlab Conical Collimator.
The surface of the Brainlab Conical Collimators is nickel- plated. If the labeling requires
special surface preparation, make sure to use a suitable cleaning agent.
Brainlab does not assume responsibility for the correct functioning of a non-Brainlab Cone
Identification System.
Brainlab excludes any liability resulting from a mismatch between the customer label or third-party
label and the Brainlab Conical Collimator size.
Brainlab requires that Brainlab Conical Collimators on Varian LINACs are used only in
combination with a cone verification system or process (e.g. Varian BCCV).
46
Figure 18
Hardware User Guide Rev. 4.9 RT / RS Stereotactic Hardware