Third-Party Labels On The Brainlab Collimator Mount - Brainlab RT/RS Hardware User's Manual

Collimator Mount
2.3.5

Third-Party Labels on the Brainlab Collimator Mount

General Information
Brainlab has authorized users and third-party linear accelerator manufacturers to attach labels to
the Brainlab Collimator Mount. Brainlab warrants that the terms of Brainlab warranty of service,
where applicable, will not be affected if the instructions below are followed.
Placing Labels
Those labels may only be placed within the area depicted in Figure 14:
Safety Notes
The applied label may only be placed at the Collimator Mount within the specified area.
Make sure that the applied label does not hinder safe and rigid attachment of the
Collimator Mount to the LINAC.
The surface of the Brainlab Collimator Mount is nickel-plated. If the labeling requires
special surface preparation, make sure to use a suitable cleaning agent.
Brainlab does not assume responsibility for the correct functioning of a non-Brainlab Linac
Accessory Identification System.
Brainlab excludes any liability resulting from a mismatch between the customer label or third-party
label and the Brainlab Collimator Mount.
For further information related to the non-Brainlab Linac Accessory Identification System please
contact the manufacturer directly.
40
Figure 14
Hardware User Guide Rev. 4.9 RT / RS Stereotactic Hardware