Parts List - Alpha ESS SMILE5 AU Installation, Operation & Maintenance Manual

INTRODUCTION
WARNING
Risk of chemical burns from electrolyte or toxic gases.
During standard operation, no electrolyte shall leak from the battery pack and no
toxic gases shall form. Despite careful construction, if the Battery Pack is damaged
or a fault occurs, it is possible that electrolyte may be leaked or toxic gases formed.
Do not install the system in any environment of temperature below -10°C or over
50°C and in which humidity is over 85%.
Do not touch the system with wet hands.
Do not put any heavy objects on top of the system.
Do not damage the system with sharp objects.
Do not install or operate the system in potentially explosive atmospheres or
areas of high humidity.
Do not mount the inverter and the battery pack in areas containing highly
flammable materials or gases.
If moisture has penetrated the system (e.g. due to a damaged enclosure), do not
install or operate the system.
Do not move the system when it is already connected with battery modules.
Secure the system to prevent tipping with restraining straps in your vehicle.
The transportation of AlphaESS SMILE5 must be made by the manufacturer or an
instructed personal. These instructions shall be recorded and repeated.
A certified ABC fire extinguisher with minimum capacity of 2kg must be carried
along when transporting.
It is totally prohibited to smoke in the vehicle as well as close to the vehicle when
loading and unloading.
For the exchange of a battery module, please request for new hazardous goods
packaging if needed, pack it and let it be picked up by the suppliers.
In case of contact with electrolyte, rinse the affected areas immediately with
water and consult a doctor without delay.
CAUTION:
Risk of injury through lifting or dropping the system.
The inverter and battery are heavy. There is risk of injury if the inverter or battery is
lifted incorrectly or dropped during transport or when attaching to or removing
from the wall.
Lifting and transporting the inverter and battery must be carried out by more
than 2 people.

1.5 Parts List

Check the following parts list to ensure it is complete.
AlphaESS delivers a total system separately on site to client, this consists of:
05 06
4x M8*60
2x M4 Nuts
SUS304
1x Meter
(1x SM60A or 1x ADL3000
or 1x ACR10R)
6xφ8*60
2x Power Cable
6x M6 Gasket
SMILE5-INV
4x M6 Nuts 1x Wall Bracke
1 x WiFi module 2xAC connectors for
(optional) grid and backup
SMILE5-BAT
6x M5*10 6x M4*10
1x User Manual Battery Communication Cable
(1 black, 1 red)
INTRODUCTION
1x Position 2x PV
Plate Connector
1x Installation 1x User
Manual Manual
2x Mounting Panel