Installing Ez-Kit Lite Usb Driver - Analog Devices ADSP-2191 EZ-KIT Lite Manual

3. Plug the provided power supply into
board. Visually verify that the green power LED (
verify that the two red reset LEDs (
moment and then go off.
4. Connect one end of the USB cable to an available full speed USB
port on your PC and the other end to
EZ-KIT Lite board.

Installing EZ-KIT Lite USB Driver

The EZ-KIT Lite evaluation system installed on Windows 98, Windows
2000, and Windows XP requires one full-speed USB port.
• "Windows 98 USB Driver Installation" on page 1-8
installation on Windows 98.
• "Windows 2000 USB Driver Installation" on page 1-12
the installation on Windows 2000.
• "Windows XP USB Driver Installation" on page 1-13
the installation on Windows XP.
The USB driver used by the debug agent is not Microsoft certified because
it is intended for a development or laboratory environment, not a com-
mercial environment.
ADSP-2191 EZ-KIT Lite Evaluation System Manual
Getting Started
on the EZ-KIT Lite
P13
LED1
and ) go on for a
LED2 LED3
on the ADSP-2191
P1
describes the
) is on. Also
describes
describes
1-7