Table of Contents
Advertisement
To install the USB driver:
1. If VisualDSP++ 3.5 is already installed on your system, go to
step 2. Otherwise, insert the VisualDSP++ CD-ROM into the
CD-ROM drive and run VisualDSP++ 3.5 installation. Refer to
the Installation Quick Reference Card for VisualDSP++ for a
detailed installation description.
When installing VisualDSP++ 3.5 on Windows 2000, make sure
that the appropriate EZ-KIT Lite component is selected for the
installation.
2. Connect the EZ-KIT Lite device to your PC's USB port.
Windows 2000 automatically detects an EZ-KIT device and auto-
matically installs the appropriate driver for the selected device (see
step 1).
3. Verify the installation by following the instructions in
Driver Installation" on page 1-15
Windows XP USB Driver Installation
VisualDSP++ 3.5 installation software pre-installs the necessary drivers for
the selected EZ-KIT Lite. The installation also upgrades an older driver if
such is detected in the system.
#
Prior to running the VisualDSP++ 3.5 installer, ensure there are no
other Hardware Wizard windows running in the background. If
any wizard windows are running, close them before starting the
installer.
To install the USB driver:
1. If VisualDSP++ 3.5 is already installed on your system, go to
step 2. Otherwise, Insert the VisualDSP++ CD-ROM into the CD
drive and run the VisualDSP++ 3.5 installation. Refer to the Instal-
lation Quick Reference Card for VisualDSP++ for a detailed
ADSP-2191 EZ-KIT Lite Evaluation System Manual
Getting Started
"Verifying
1-13
Advertisement
Table of Contents
Need help?
Do you have a question about the ADSP-2191 EZ-KIT Lite and is the answer not in the manual?
Questions and answers