Hydraulic System - Husqvarna Rider 213C Workshop Manual

4. Push the new fuel filter into the ends of the hoses.
Apply liquid detergent to the ends of the fuel filter to
make the connection easier.
5. Push the hose clips against the fuel filter.
9.4.2 To remove the fuel tank
WARNING: Gasoline is very flammable and
dangerous for the environment. Make sure to
prevent fire and spill.
1. Remove the fender above the fuel tank. See
remove the covers on page 20
2. Put a container below the fuel tank to collect the
gasoline. For information about fuel tank capacity,
Technical data on page 59
see
3. Compress the fuel tank hose to prevent leakage.
4. Disconnect the fuel tank hose from the lower
connection of the fuel filter.
5. Pull the hose through the frame.
6. Put the end of the hose into the container and empty
the fuel tank.
7. Remove the cable and lift the fuel tank.
9.4.3 To assemble the fuel tank
WARNING: Gasoline is very flammable and
dangerous for the environment. Make sure to
prevent fires and prevent spills.
CAUTION: Make sure the hose is not damaged.
Note: Empty the tank before assembly to make the
assembly easier.
1. Push the fuel hose through the bracket and put the
tank on the bracket.
2. Attach the cable around the tank.
3. Push the fuel hose through the frame.
4. Attach the fuel hose to the fuel filter.
36 - Repair instructions
5. Fill the tank with gasoline and do a check that there
are no leaks.
6. Attach the fender.

9.5 Hydraulic system

9.5.1 Hydraulic system overview
To
9.5.2 To keep the hydraulic system clean
• Make sure the parts and the area around them are
clean before opening the filling cap or disconnecting
parts of the transmission.
• Use clean containers with new oil.
• Only use clean oil that has been kept in sealed
containers.
• Do not use drained oil again.
• Obey the oil and filter change intervals specified in
the Maintenance schedule. See
schedule for the service center on page 13 .
It is necessary to keep the hydraulic system free from
contamination. Particles caused by the moving parts of
the transmission can cause wear damage and
malfunctions. The transmission oil filter remove
contaminations from the oil. If dirt enters the system the
filters will quickly get blocked and will not work. This will
result in malfunction and it will be necessary to clean the
system.
Do not open the hydraulic system unless it is necessary.
Each time the transmission i opened increases the risk
of contamination although the work is made by a
professional service center.
9.5.3 Oil leaks
WARNING: Oil is dangerous to the environment
and leakage can cause damage to the lawn.
CAUTION: Oil leakage can cause damage to
the transmission and make it wear it out faster.
Repair oil leaks immediately.
Maintenance
934 - 002 - 25.06.2019