Fuel System - Husqvarna Rider 213C Workshop Manual

4. Adjust the microswitch until it clicks when the
parking brake is pushed approximatley 40 mm / 1.5
in.
Note: Remove the spring for the parking brake cable
to make it easier to get access to the microswitch.
5. Attach the transmission cover and the frame tunnel
cover.
9.3.8 To remove and install the microswitch for the
lift lever
1. Remove the right footrest plate and the right fender.
To remove the covers on page 20
Refer to
2. Disconnect the connector from the microswitch.
3. Remove the microswitch.
4. Install in opposite sequence.
934 - 002 - 25.06.2019
9.3.9 To disassemble and assemble the ignition
switch
1. Remove the side cover on the control panel.
2. Remove the ignition key.
3. Remove the plastic nut and pull down the ignition
switch.
4. Pull the connector to disconnect it from the ignition
switch.
5. Assemble in opposite sequence. Make sure that the
connector goes into the correct position.

9.4 Fuel system

9.4.1 To replace the fuel filter
1. Open the engine cover to get access to the fuel
filter.
2. Move the hose clips away from the fuel filter with a
pair of flat pliers.
3. Pull off the fuel filter from the hose ends. A small
quantity of fuel can leak.
Repair instructions - 35