Husqvarna Rider 213C Workshop Manual page 45

8. Put the hydrostatic transmission cable in the rear
casing bracket and attach the rear clamp (B).
B
A
9. Adjust the hydrostatic transmission cable. Refer to
To adjust the hydrostatic transmission cable on page
44 .
10. Connect the rear ball joint (A).
11. Put the locking spring into the hole (A) and push it
around the ball joint shaft (B).
A
12. Tighten the locknut for the rear ball joint.
13. Attach the frame tunnel cover. Refer to
the covers on page 20 .
14. Operate the product forward and rearward to make
sure that the transmission operates correctly.
9.5.12 Transmission maintenance
9.5.12.1 To adjust the transmission neutral position
WARNING: Engine exhaust contains poisonous
carbon monoxide. Attach an exhaust hose
before you start the engine indoors.
1. Bleed the hydraulic system. Refer to
drive system on page 37 .
2. Put the product on the adjustment tool for wheel
Servicing tools on page 15 .
speed. Refer to
3. Start the engine and give it full throttle.
934 - 002 - 25.06.2019
4. Loosen the locknut (A) on the transmission
5. Turn the adjustment shaft (B) clockwise until the
6. Make a mark at the position where the wheels start
B
To remove
7. Turn the adjustment shaft (B) counterclockwise until
8. Make a mark at the position where the wheels start
9. Turn the adjustment shaft (B) clockwise to the
10. Hold the adjustment shaft (B) and tighten the locknut
To bleed the
9.5.12.2 To replace the oil in the front and rear
hydrostatic transmissions
adjustment shaft.
A
B
wheels start to turn rearward.
to turn (C).
C
the wheels start to turn forward.
to turn (D).
middle position between the marks (E).
(A).
WARNING: Transmission oil is dangerous to
your skin. Clean spills with soap and water.
WARNING: Used oil and filters are dangerous
to the environment. Discard used chemicals at
an applicable disposal location.
B
A
D
E
Repair instructions - 45