Table of Contents
Advertisement
c) Turn the oil drain plug counterclockwise and pull
out to open it.
3. Remove the dipstick.
4. Let the oil run out into the container.
5. Attach the oil drain plug.
6. Push the oil drain plug in and turn it clockwise to
close it.
7. Remove the plastic hose and put the cap on the oil
drain plug.
8. Turn the oil filter counterclockwise to remove it.
9. Lightly lubricate the rubber seal on the new oil filter
with new oil.
10. Turn the oil filter clockwise by hand until the rubber
seal is in position, then tighten a half turn more.
Technical data on page
11. Fill with new oil as given in
59 .
12. Start the engine and let it operate at idle speed for 3
minutes.
13. Stop the engine and make sure that there are no
leaks.
14. Fill with oil to make up for the oil held in the new oil
filter.
9.2.4 To do a check of the transmission oil level
Note: Do the transmission oil check when the
transmission is cool.
1. Put the product on a horizontal surface.
2. Remove the screws, one on each side, and remove
the transmission cover.
3. Make sure that the oil level in the transmission oil
tank is between the 2 horizontal lines on the tank.
Max
Min
4. Fill with oil if the oil level is below the lower line, but
Technical data
do not fill above the top line. Refer to
on page 59 for recommended oil.
9.2.5 To clean and change the air filter
1. Open the engine cover.
2. Loosen the knobs that hold the filter cover and lift off
the cover.
3. Lift the end of the air filter to remove it.
4. Hit the paper filter against a hard surface to clean it.
Do not use compressed air.
5. If the paper filter does not become clean, replace it.
6. Put the clean air filter on the air hose.
7. Push the air filter into correct position.
8. Attach the air filter cover and tighten the knobs.
Repair instructions - 29
Hide quick links:
Advertisement
Table of Contents
