Husqvarna Rider 213C Workshop Manual page 49

4. Assemble the new blade with the bent ends in the
direction of the cutting deck.
WARNING: Incorrect blade type can cause
objects to eject from the cutting deck and
cause serious injury. Use only the blades
Technical data on page 59 .
given in
5. Attach the blade, the washer and the bolt. Tighten
the bolt with the correct tightening torque. Refer to
Tightening torques on page 61 .
9.6.7 To disassemble the blade bearings
1. Remove the covers on the cutting deck.
2. Remove the belts.
3. Remove the screws that hold the pulley. Lock the
blade with a wooden block.
4. Remove the pulley. Use a puller if it is necessary.
5. Loosen the 4 screws that hold the blade bearing and
remove the bearing assembly from the cutting deck.
934 - 002 - 25.06.2019
6. Put the bearing housing in a vise and remove the
blade and washers.
7. Remove the protective washer.
8. Make a mark on one end of the shaft. Push out the
shaft with a puller. Tap out the bearing and remove
the spacer.
Repair instructions - 49