Hydraulic System - Husqvarna R112C Workshop Manual

6. Push the hose clips against the fuel filter.
9.4.2 To remove and install the fuel tank
WARNING: Gasoline is very flammable and
dangerous to the environment. Refer to
safety instructions on page 4 .
1. Remove the engine cover. Refer to
engine cover on page 21 .
2. Remove the engine side covers. Refer to
the engine side covers R115C on page 21 .
3. Remove the fuel tank cover. Refer to
fuel tank cover on page 21 .
4. Put a container below the fuel tank to collect the
fuel.
5. Compress the fuel tank hose to prevent leakage.
6. Loosen the hose clamp and remove the fuel tank
hose from the lower connection of the fuel filter.
7. Put the end of the hose into the container and drain
the fuel.
8. Remove the 2 screws and the fuel tank.
1342 - 002 -
Special
To remove the
To remove
To remove the
9. Pull the hose through the frame.
10. Install in the opposite sequence.
11. Fill the tank with fuel and do a check that there are

9.5 Hydraulic system

9.5.1 Oil leaks
Repair oil leaks immediately.
a) For models R112C, R112C5.
b) For model R115C.
no leaks.
WARNING: Oil is dangerous to the environment
and leakage can cause damage to the lawn.
CAUTION: Oil leakage can cause damage to
the transmission and make it wear it out faster.
Repair instructions - 37