Husqvarna Rider 213C Workshop Manual page 21

9.1.1.4 To remove the right footrest plate
1. Turn the knob on the reverse pedal (A) to remove it.
2. Remove the 3 screws (B) and remove the footrest
plate.
B
9.1.1.5 To remove the left footrest plate
• Remove the 4 screws and remove the footrest plate.
9.1.1.6 To remove the right side cover
1. Remove the right footrest plate. Refer to
the right footrest plate on page 21 .
Note: 2 of the screws of the footrest plate also hold
the right side cover.
2. Remove the 2 screws and remove the right side
cover.
934 - 002 - 25.06.2019
B
A
B
B
To remove
9.1.1.7 To remove the transmission cover
• Remove the 2 screws and remove the transmission
cover.
9.1.1.8 To remove the frame tunnel cover
1. Remove the 2 screws (A).
2. Push the frame tunnel cover rearward (B) and lift the
front end of the frame tunnel cover (C).
9.1.2 Throttle cable
9.1.2.1 To do a check of the throttle cable
Make sure that the engine speed changes when the
throttle is changed. Do a check that the engine gets the
correct speed at full throttle. See
59
C A
B
Technical data on page
Repair instructions - 21