Transport Safety; To Safely Attach The Product For Transport - Husqvarna Rider 213C Workshop Manual

Never use the product if persons,
especially children, or animals, are in the
vicinity.
Look behind you before and while you
move the product in reverse.
Never cut grass across a slope. Do not
cut grass on ground that slopes more than
10°.
Never carry passengers on the product or
equipment.
Move forward.
Neutral gear.
Move rearward.
Parking brake.
This product is in accordance with
applicable EC directives.
Noise emission to the environment
according to the European Community's
Directive. The product's emission is
specified in the Technical data chapter
and on the label.
Always use approved hearing protection.
Stop the engine.
Start the engine.
Engine speed – fast.
Engine speed – slow.
Fuel.
Max. ethanol 10%.
934 - 002 - 25.06.2019
Cutting height.
Servicing position for the cutting height
lever.
The blades are engaged.
The blades are disengaged.
Servicing position for the cutting deck.
Operation position for the cutting deck.
Engage and disengage the drive system.
Oil level.
Note: Other symbols/decals on the product refer to
certification requirements for some commercial areas.

2.6 Transport safety

• Use an approved transport vehicle for transportation
of the product.
• A markets national or local regulations can set limit
to the transportation of the product.
• The operator of the transport vehicle is responsible
to attach the product safely during transport.

2.7 To safely attach the product for transport

Before you attach the product, you must read and
understand the safety chapter. Refer to
on page 5 .
WARNING: The parking brake is not sufficient
to lock the product during transport. Attach the
product tightly to the load area.
Equipment: 2 approved straps and 4 wedge shaped
wheel blocks.
1. Park the product in the center of the load area.
Transport safety
Safety - 5