Husqvarna Rider 213C Workshop Manual page 56

9.9.7 To replace the belt on the cutting deck
1. Remove the cutting deck. Refer to
attach the cutting deck on page 8 .
2. Remove the 4 screws and lift the frame.
3. Turn the tension pulley (A) to the side.
B
4. Remove the 2 screws (B) on the cutting deck cover
and remove the cutting deck cover.
5. Loosen the belt tension spring (A) and remove the
belt (B).
B
6. Install the new belt in opposite sequence.
Note: A decal on the inner side of the cutting deck
cover shows how to install the belt correctly.
56 - Repair instructions
To remove and
A
A
934 - 002 - 25.06.2019